ICRA 2012 Paper Abstract

Close

Paper TuD03.6

Sawada, Daisuke (Ritsumeikan University), Ozawa, Ryuta (Ritsumeikan University)

Joint Control of Tendon-Driven Mechanisms with Branching Tendons

Scheduled for presentation during the Regular Session "Cable-Driven Mechanisms" (TuD03), Tuesday, May 15, 2012, 17:45−18:00, Meeting Room 3 (Mak'to)

2012 IEEE International Conference on Robotics and Automation, May 14-18, 2012, RiverCentre, Saint Paul, Minnesota, USA

This information is tentative and subject to change. Compiled on December 13, 2017

Keywords Tendon/Wire Mechanism, Motion Control of Manipulators

Abstract

This paper proposes a joint control method for tendon-driven mechanisms (TDMs) with branching tendons that are connected to multiple tendons at a point, and which are often found in musculoskeletal systems. TDMs usually require the same number of tendons as actuators, which are one of the heaviest components in a robotics system. The utilization of branching tendons is useful for reducing the number of actuators needed for making lightweight robotic mechanisms, such as prosthetic hands. However, the under-actuation of the branching tendons makes it difficult to accurately control the joint motion of TDMs. Therefore, TDMs with branching tendons have been used only for simple adaptive grasping mechanisms. In this paper, we derive the tendon kinematics of TDMs with branching tendons and design a joint PD controller for the mechanisms. We demonstrate the stability of the control system using Lyapunov's direct method. We show that the bias force setting, which does not appear in conventional TDMs, is important in the realization of accurate control in TDMs with branching tendons. Simulations were performed to evaluate the proposed method.

 

 

Technical Content © IEEE Robotics & Automation Society

This site is protected by copyright and trademark laws under US and International law.
All rights reserved. © 2002-2017 PaperCept, Inc.
Page generated 2017-12-13  22:19:03 PST  Terms of use