The 6th annual IEEE Conference on Automation Science and Engineering

CASE 2010 Paper Abstract


Paper SuC4.1

Kleinigger, Michael (Rensselaer Polytechnic Institute, Center for Automation Technolo), Rock, Stephen (Rensselaer Polytechnic Institute)

Application of 6-DOF Sensing for Robotic Disturbance Compensation

Scheduled for presentation during the Regular Session "Industrial Robotic Systems" (SuC4), Sunday, August 22, 2010, 16:00−16:20, Bay

6th annual IEEE Conference on Automation Science and Engineering, August 21-24, 2010, Marriott Eaton Centre Hotel, Toronto, Ontario, Canada

This information is tentative and subject to change. Compiled on December 10, 2018

Keywords Construction Robotics and Automation, Information-based Manufacturing, Manufacturing Systems


In the future of manufacturing and construction, the need will arise for robots that operate in larger work envelopes than can be supported using traditional fixed-base industrial robot systems. Robots may instead be mounted to mobile equipment subject to disturbance. Such disturbance may be compensated using robot arm motions if sufficiently precise and rapid sensing and control systems are available. In this paper we present the development of a disturbance compensation system using a Stšubli TX90 six axis industrial robot and controller. This is coupled with a developmental six degree of freedom sensor package capable of high bandwidth, accurate sensing throughout the workspace. The robot is mounted to an uncontrolled moveable platform. Sensor measurements are then processed and fed into the Stšubli CS8C controller in order to successfully stabilize the end-effector.



Technical Content © IEEE Robotics & Automation Society

This site is protected by copyright and trademark laws under US and International law.
All rights reserved. © 2002-2018 PaperCept, Inc.
Page generated 2018-12-10  22:52:53 PST  Terms of use